Show simple item record

dc.contributor.authorHearn, Christopher Rae
dc.date.accessioned2012-10-26T02:51:08Z
dc.date.available2012-10-26T02:51:08Z
dc.date.issued1994
dc.identifier.urihttp://hdl.handle.net/10179/3969
dc.description.abstractThe operation and performance of anaerobic digesters treating thermomechanical pulping wastewater was investigated. The aim of this work was to develop a reactor design that could successfully treat the wastewater with minimal pretreatment. Six reactors were trialed, all modifications of the upflow anaerobic sludge blanket [UASB] reactor design. Seed sludge source, start-up regime and suspended solids retention were varied to determine effective operation methodology. A screw press effluent from Pan Pacific Forestry Industries Ltd thermomechanical pulp [TMP] mill at Whirinaki, North Island, New Zealand was used as feed for all of the reactors. Seed sludge was obtained in granular form from UASB reactors treating dairy industry wastewaters and in nongranular form from the aerated lagoons of the New Zealands central North Island pulp mills. Operation of all six experimental reactors was difficult due to many feed blockages caused by the relatively high suspended solids concentration in the feed. Inhibition was frequently observed after feed interruptions with slow recovery of performance, possibly due to the lack of a co-metabolite soon after the feed supply ceased. Many modifications to the reactor inlet and feed system greatly reduced blockage problems. In the later reactors a low suspended solids retention allowed granulation to be achieved from a non-granular forestry industry sludge. With the final reactor configuration total COD removals of 50-60% and dissolved COD removals of 70-85% were achieved at organic loading rates up to 40 kgCOD.m-3.d-1. A 20 to 50 % conversion of feed suspended solids to methane was calculated on a COD basis. Granulation was achieved without a gas-solids-separator. This was attributed to the need for severe selection against poorly settling wood suspended solids, and the presence and precipitation of iron. The granules were approximately 37% iron on a dry weight basis and had densities averaging 2000 kg.m-3. Scanning electron microscope work indicated that extensive precipitates, presumed to be iron based complexes, were responsible for the structural integrity of the granule. An abundant layer of bacteria of predominantly Methanothrix morphotypes was found beneath the surface of the granules. The granules have been demonstrated to provide some protection from inhibition, probably by diffusional gradients. After five years exposure to TMP wastewater a dissolved extract of feed resin acids exerted an inhibitory effect on granules at similar concentrations to that reported for dehydroabietic acid with unacclimated granules. Thus no acclimation to soluble resin acids was evident. Changes in the distribution of resin acids suggested that some degree of resin acid dissolution occurs within the reactors but degradation of the total concentration of resin acids is poor, averaging 10 % reduction as total acids. Overall, the final reactor design has proved to be an effective treatment of TMP wastewater. Suspended solids removal rates are not high but equally the suspended solids do not threaten the viability of the reactor system. Changes in the nature of the suspended solids passing through the reactor are such that subsequent suspended solids removal will be more efficient and have a lower loading rate than for the untreated wastewater. The reactor has demonstrated a high degree of ability to accept large variations in feed rate and strength and still function efficiently. The work has produced the basis for a successful primary reactor design for the treatment of a problem wastewater and the necessary information on which a pilot scale plant could be designed for high suspended solids wastewaters. A possible method for the cultivation of granules in difficult wastewaters has been identified.en
dc.language.isoenen
dc.publisherMassey Universityen_US
dc.rightsThe Authoren_US
dc.subjectWastewater treatmenten
dc.subjectPulp millen
dc.subjectForestry industry sludgeen
dc.titleAnaerobic treatment of thermo-mechanical pulp mill waste water : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Process and Environmental Technology at Massey Universityen
dc.typeThesisen
thesis.degree.disciplineProcess and Environmental Technologyen
thesis.degree.grantorMassey Universityen
thesis.degree.levelDoctoralen
thesis.degree.nameDoctor of Philosophy (Ph.D.)en


Files in this item

Icon
Icon

This item appears in the following Collection(s)

Show simple item record