Repository logo
    Info Pages
    Content PolicyCopyright & Access InfoDepositing to MRODeposit LicenseDeposit License SummaryFile FormatsTheses FAQDoctoral Thesis Deposit
    Communities & Collections
    All of MRO
  • English
  • العربية
  • বাংলা
  • Català
  • Čeština
  • Deutsch
  • Ελληνικά
  • Español
  • Suomi
  • Français
  • Gàidhlig
  • हिंदी
  • Magyar
  • Italiano
  • Қазақ
  • Latviešu
  • Nederlands
  • Polski
  • Português
  • Português do Brasil
  • Srpski (lat)
  • Српски
  • Svenska
  • Türkçe
  • Yкраї́нська
  • Tiếng Việt
Log In
New user? Click here to register using a personal email and password.Have you forgotten your password?
  1. Home
  2. Browse by Author

Browsing by Author "Hoang DK"

Filter results by typing the first few letters
Now showing 1 - 1 of 1
  • Results Per Page
  • Sort Options
  • Loading...
    Thumbnail Image
    Item
    Thermo-economic investigation and multi objective optimization of cascade high temperature heat pump using low global warming refrigerants
    (Elsevier B.V., 2025-11-15) Hoang DK; Walmsley TG; Cleland DJ; Chen Q; Carson JK
    High temperature heat pumping (HTHP) is a key technology for decarbonizing industrial process heat. This paper describes an investigation into the thermodynamic and economic performance of a cascade HTHP configured with internal heat exchangers (IHXs), using low global warming potential (GWP) refrigerants in both the top cycle and the bottom cycle. The proposed system was applied to a spray dryer case study with supply air temperature over 200 °C. A differential evolution (DE) method was used to optimize operating parameters to obtain the maximum COP. The simulation results indicated that of the cycles and refrigerants considered, the maximum COP can be obtained when using acetone or ethanol in the top cycle (TC) and butane or neopentane in the bottom cycle (BC). The use of acetone/neopentane and ethanol/neopentane achieved a highest COP of 2.42; however, better economic performance was achieved when using butane as the BC refrigerant rather than neopentane, while the economic and thermodynamic performance of the heat pumps were similar when acetone and ethanol were used as TC refrigerants. The performance of the most promising refrigerants was analyzed under off-design conditions, with minimum and maximum COP being 2.19 and 2.82, respectively obtained with the sink inlet/outlet temperature of 50 °C/230 °C and 15 °C/200 °C.

Copyright © Massey University  |  DSpace software copyright © 2002-2026 LYRASIS

  • Contact Us
  • Copyright Take Down Request
  • Massey University Privacy Statement
  • Cookie settings
Repository logo COAR Notify