Laser ablation assisted micropattern screen printed transduction electrodes for sensing applications

In this work we present a facile method for the fabrication of several capacitive transduction electrodes for sensing applications. To prepare the electrodes, line widths up to 300 μm were produced on polymethyl methacrylate (PMMA) substrate using a common workshop laser engraving machine. The geometries prepared with the laser ablation process were characterised by optical microscopy for consistency and accuracy. Later, the geometries were coated with functional polymer porous cellulose decorated sensing layer for humidity sensing. The resulting sensors were tested at various relative humidity (RH) levels. In general, good sensing response was produced by the sensors with sensitivities ranging from 0.13 to 2.37 pF/%RH. In ambient conditions the response time of 10 s was noticed for all the fabricated sensors. Moreover, experimental results show that the sensitivity of the fabricated sensors depends highly on the geometry and by changing the electrode geometry sensitivity increases up to 5 times can be achieved with the same sensing layer. The simplicity of the fabrication process and higher sensitivity resulting from the electrode designs is expected to enable the application of the proposed electrodes not only in air quality sensors but also in many other areas such as touch or tactile sensors.

Keywords

Electrodes, Humidity, Laser Therapy, Lasers

Citation

Sci Rep, 2022, 12 (1), pp. 6928 - ?

Collections

Journal Articles

Full item page