Show simple item record

dc.contributor.authorLeonard, Anne M.
dc.date.accessioned2011-10-27T00:46:51Z
dc.date.available2011-10-27T00:46:51Z
dc.date.issued1996
dc.identifier.urihttp://hdl.handle.net/10179/2806
dc.descriptionData files held on disks with thesis print copy in Library.en_US
dc.description.abstractThe typical wastewater from a milk processing facility producing butter and milk powder was treated in a modified activated sludge system in order to establish process characteristics and investigate operational problems. A synthetic wastewater was developed with similar average physical and chemical characteristics to that from a full scale facility. The relative biodegradability of the wastewater fractions was assessed and basic microbial growth parameters also determined. A laboratory scale activated sludge reactor configuration was then established and its performance monitored. Although effective treatment was achieved in terms of suspended and soluble organic matter removal, the use of a completely mixed reactor resulted in the system becoming inoperable due to the excessive growth of filamentous microorganisms, with Type 0411 being the dominant filament. In order to inhibit filamentous bulking, various selector reactor configurations were trialed. As nitrification of feed stream proteins had been indicated, unaerated selectors were used with the intention of effecting anoxic substrate removal in the initial selector zone; but due to the limited supply of oxidised nitrogen, insufficient substrate removal occurred in the selectors to prevent filamentous bulking, with Type 021N becoming dominant. The next series of trials used aerated selectors, with some configurations demonstrating the ability to both prevent and cure filamentous bulking. The unsuccessful trials resulted in the proliferation of Haliscomenobacter hydrossis. From selector trials conducted it was established that the requirements for successful suppression of filamentous growth were the incorporation of an initial selector zone in which greater than 95% of removable soluble substrate was removed and the bulk solution was maintained in a fully aerobic state. Serial selector configurations demonstrated improved performance over a single selector. From observations of the physical conditions and substrate concentrations in the reactor configurations employed, a correlation of filament type to environmental condition can be tentatively made: Types 0411 and 021N were indicated to be low organic loading type filaments, whereas H. hydrossis was indicated to be a low dissolved oxygen filament. Rapid substrate removal rates were attributed to biosorption, accumulation and storage mechanisms, increasing as the selector configuration trials progressed. In general floc formers possessed a higher specific growth rate and substrate affinity than the filamentous microorganisms. Filament Type 021N was indicated to lack biosorptive capacity, however H. hydrossis was indicated as having a greater biosorptive capacity than the floc formers present. The highly degradable nature of the substrate and high substrate concentration gradients imposed by the selector configuration caused rapid oxygen uptake rates; resulting in aerobic, anoxic and anaerobic substrate removal mechanisms all occurring in the initial selector zone. The occurrence of simultaneous nitrification, denitrification and phosphorus accumulation resulted in significant nutrient removals from the aerated selector reactor system, with influent nitrogen and phosphorus levels each reduced by up to 96% in the effluent stream. This study found that an activated sludge process was an appropriate method for the effective treatment of milk processing wastewaters, as effluent suspended solids of less than 10 g.m-3 and soluble COD of less than 30 g.m-3 were consistently obtained, however a modified configuration would be required to prevent the growth of filamentous microorganisms and attendant operability problems. Due to the nature of dairy processing wastewaters, a selector reactor configuration could be employed not only to overcome potential filamentous bulking problems, but also to provide an opportunity for biological nutrient removal without the inclusion of dedicated anoxic / anaerobic reaction steps or the complex flow regimes conventionally employed for nutrient removal activated sludge systems.en_US
dc.language.isoenen_US
dc.publisherMassey Universityen_US
dc.rightsThe Authoren_US
dc.subjectSewage purificationen_US
dc.subjectSewerage purificationen_US
dc.subjectActivated sludge processen_US
dc.subjectDairy waste purificationen_US
dc.subjectDairy processing wastewateren_US
dc.subjectActivated sludge treatmenten_US
dc.titleActivated sludge treatment of dairy processing wastewaters : the role of selectors for the control of sludge bulking : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy at Massey Universityen_US
dc.typeThesisen_US
thesis.degree.disciplineEnvironmental Engineering
thesis.degree.grantorMassey University
thesis.degree.levelDoctoral
thesis.degree.levelDoctoralen
thesis.degree.nameDoctor of Philosophy (Ph.D.)


Files in this item

Icon
Icon

This item appears in the following Collection(s)

Show simple item record