Show simple item record

dc.contributor.authorBennett, Hayden Albert Edward
dc.date.accessioned2015-12-13T19:38:58Z
dc.date.available2015-12-13T19:38:58Z
dc.date.issued2000
dc.identifier.urihttp://hdl.handle.net/10179/7356
dc.description.abstractWhole milk fouling of surfaces within dairy products processing plants, especially that which occurs on heat treatment equipment, is an important operating problem, threatening the quality of product and reducing thermal and mechanical efficiency of equipment. A fouling monitoring system was developed using a commercial heat flux probe and temperature sensor. The fouling monitor was installed in two unit operations of a custom built milk powder pilot plant. The unit operations replicated heat treatments found in plate heat exchangers and falling film evaporators. The research plate heat exchanger consisted of six miniature plate heat exchangers or modules in series. Individual modules could be isolated at any point during a run allowing access to the fouling deposit. The research falling film evaporator was a flat plate attached to a steam chamber and milk weir box. The onset and build-up of whole milk fouling on the evaporator plate was viewed through a sight window installed in the evaporator casing. Trials conducted with the research plate heat exchanger showed that the monitoring system could detect whole milk fouling in terms of a reduction in the overall heat transfer coefficient. This reduction was shown to directly correspond to an increase in fouling deposit thickness. For the same bulk milk temperature, the fouling rate decreased significantly when the surface was unheated compared with heated surfaces. This observation lead to a set of experiments that manipulated the start up procedure on both the milk and heating medium side of the research plate heat exchanger. More fouling was observed on plates after air start up (on the milk side) than on plates after water start up. Similarly, Surface Conditioning by Operational Protocol (SCOP) extended the fouling induction period. The SCOP trials compared steady state heating with unsteady state heating during start-up. Similar amounts of fouling were observed on plates removed from the steady state heated modules after 30 minutes and on plates removed from the unsteady state modules after 9 hours. These results indicate that the state of the stainless steel surface when the. milk first makes contact has an important effect on the subsequent rate of fouling. It is recommended that future work aims to identify which milk components deposit first onto the surface and what influence they have on inhibiting or facilitating fouling. The fouling monitoring system successfully estimated the extent of fouling for all of the trials. Industry trials for the fouling monitoring system, particularly on heated surfaces are recommended. The system will allow local areas of intense fouling to be mapped within the processing plants. A number of recommendations are presented concerning future work associated with start up procedure manipulation, evaporator trials and seasonal variation trials.en_US
dc.language.isoenen_US
dc.publisherMassey Universityen_US
dc.rightsThe Authoren_US
dc.subjectDairy processingen_US
dc.subjectHeat exchangesen_US
dc.titleWhole milk fouling of heated surfaces : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology in Food Engineering at Massey Universityen_US
dc.typeThesisen_US
thesis.degree.disciplineFood Engineeringen_US
thesis.degree.grantorMassey Universityen_US
thesis.degree.levelMastersen_US
thesis.degree.nameMaster of Technology (M. Tech.)en_US


Files in this item

Icon
Icon

This item appears in the following Collection(s)

Show simple item record