Show simple item record

dc.contributor.authorXie, Li
dc.date.accessioned2016-06-21T03:34:31Z
dc.date.available2016-06-21T03:34:31Z
dc.date.issued2016
dc.identifier.urihttp://hdl.handle.net/10179/8302
dc.description.abstractWater contamination not only affects human health, but can also damage the ecological system and the natural environment. Agriculture is the backbone of New Zealand’s economy, however the sector has been identified as a primary source of nitrate contamination in many waterways. Therefore, monitoring of water quality in agricultural areas is paramount. The contemporary measurement methodologies applied for contaminant quantification are expensive, laboratory-based and time-consuming so the development of a low-cost, convenient sensing system is required. An electrochemical impedance spectroscopy based nitrate sensing system has been developed for nitrate detection. The system is designed to measure the nitrate concentration in water is stand-alone, robust, real-time and low-cost. The microcontroller in the designed system was used to generate the excitation signal applied to the sensor; for data processing and controlling time interval for the switch on/off the automatic sample-intake pump. The data in the microcontroller is transmitted to a computer for data storage and calculation via wireless communication. As the sensor geometry used in the project is the interdigital type which is very sensitive to the temperature, therefore, the sensor was initially tested in the deionized water at variable temperatures. From the result of testing in various temperature ranges, the temperature correction factor was obtained for nitrate measurement. The calibration samples were prepared by the serial dilution of a nitrate stock solution using sodium nitrate (NaNO3) and ammonium nitrate (NH4NO3) with different concentrations. The sensor was immersed in the solution to observe the impedance change at various nitrate concentrations. The experimental result showed a good linear relationship between the concentration and real part of the measured impedance and the computational model for nitrate concentration was predicted based on the experimental results achieved. The sensor was also tested in the water samples collected from different local agricultural streams, and the results were validated with the applied laboratory testing results using contemporary techniques. The experimental results showed that the sensing system is more sensitive to the lower nitrate concentrations in the surface water. The system was prototyped and applied in the field. The real-time low-cost testing system displayed its potential for the in-situ continuous nitrate monitoring in the paddocks.en_US
dc.language.isoenen_US
dc.publisherMassey Universityen_US
dc.rightsThe Authoren_US
dc.subjectElectrochemical sensorsen_US
dc.subjectWater pollutionen_US
dc.subjectMeasurementen_US
dc.subjectNitratesen_US
dc.titleAn electrochemical impedance spectroscopy based nitrate sensor for practical application : a project report submitted in partial fulfillment of the requirements for the degree of Master of Engineering in Electrical and Electronics Engineering, School of Engineering and Advanced Technology, Massey University, Palmerston North, New Zealanden_US
dc.typeThesisen_US
thesis.degree.disciplineElectrical and Electronics Engineeringen_US
thesis.degree.grantorMassey Universityen_US
thesis.degree.levelMastersen_US
thesis.degree.nameMaster of Engineering (M.E.)en_US


Files in this item

Icon
Icon

This item appears in the following Collection(s)

Show simple item record