Can biochar ameliorate phosphorus deficiency and aluminium phytotoxicity in acid soils? : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy of Applied Science in Soil Science at Massey University, Palmerston North, New Zealand
Loading...
Date
2015
DOI
Open Access Location
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Massey University
Rights
The Author
Abstract
The use of biochar as soil amendment to enhance soil functionality is being
increasingly investigated, with particular attention given to its effects on the sustainable
increase of crop production and carbon (C) sequestration. To date, however, limited
research has attempted to unravel the effect of biochar on either the chemical and/or
biological mobilization of the residual fraction of phosphorus (P) in soil. This fraction
tends to accumulate as a result of long–term P fertilization in soils rich in aluminium
(Al) and iron (Fe) oxy–hydroxides and short–range ordered aluminosilicates (i.e.
allophane). There is also scant information on (i) how the speciation of soluble Al
changes when biochar is applied to acid soils, and (ii) whether this application alleviates
Al toxicity on plant roots. My objective in this study is therefore to determine the effect
of different biochars with contrasting fertilizer and liming values on the chemistry,
biology and nutrient fertility of acid mineral soils.
Before studying the effect of different biochars on soil properties, several
methodologies for measuring the liming properties and available nitrogen (N) in biochar
were evaluated and modified where needed. For this, 19 biochars produced by
pyrolysing a wide range of feedstocks under various production temperatures were used.
Different pH–buffering capacity (pH–BC) methodologies – originally developed for
soils (single vs multiple acid additions, short vs long equilibration times) – were tested,
along with the methodology used to measure the liming equivalence. The
methodologies were then validated by incubating over 10 d two acid soils (an Haplic
Cambisol and an Andic Umbrisol) to which separated amendments of the 19 biochars
were made at the rates estimated using both methodologies to target a final pH of 6.5
The results indicated that the relationship established between the pH–BC of the 19
biochars under study after 30–min equilibration (pH–BC30min) with a single addition of
acid and that obtained after a 5–d equilibration (pH–BC5d) (predicted pH–BC5d = 2.2 ×
pH–BC30min + 20.4) allowed an adequate estimate of the liming potential of biochars.
Similar results were found with the liming equivalent, and both methods were
considered suitable to make the recommendation of the application rate. Acid
hydrolysis using 6 M HCl has been proved adequate to determine available N in biochar.
For this, hydrolysates of biochar are oxidized using potassium peroxodisulfate with a
dilution factor of 600 so that chloride interferences are overcome and nitrate–N is then
measured. This methodology, originally developed using biochars rich in N, proved not
suitable for biochars with low N concentrations. Results obtained in this study have
shown that a smaller dilution factor (242) is sufficiently adequate to overcome the
chloride interferences while avoiding over–diluting the sample.
In this study, we hypothesized that biochar can increase P availability to plant
by stimulating the growth of arbuscular mycorrhizal fungi (AMF) hyphae. Therefore,
methodologies to (i) estimate the length of fungal hyphae in soil and (ii) evaluate the
transfer of P by AMF hyphae needed to be tested and modified where necessary. In this
part of the study, three different biochars and two soil types were used. Two biochars
were produced from chipped pine (Pinus radiata D. Don) branches at 450oC and 550°C
(referred to as BP450 and BP550, respectively); and a third one from chipped weeping
willow (Salix matsudana L.) branches at 550°C (referred to as BW550). The soils were
two sil–andic Andosols of contrasting P status (Olsen P of 4.3 vs 33.3 mg kg–1, referred
to as LP and HP soil, respectively).
The traditional visual gridline intersection (VGI) method commonly used to
measure the length of AMF hyphae distribution in soil was modified by (i) using a
digital photomicrography technique (referred to as “digital gridline intersection” (DGI)
method), and (ii) processing the images using ImageJ software (referred to as the
“photomicrography–ImageJ processing” (PIP) method). These methods were first tested
with known lengths of possum fur and then applied to measuring the hyphal length in
the LP and HP soils after a 32 wk experiment growing Lotus pedunculatus cv barsille.
The study confirmed that the use of digital photomicrography in conjunction with either
the grid–line intersection principle or image processing (with ImageJ software) is a
suitable method for the measurement of AMF hyphal lengths in soils.
In addition, the traditional root study container that divides the plant growth
medium into two sections – (i) a root zone to which both root and AMF hyphae have
access and (ii) an hyphal zone to which only AMF hyphae have access – by a layer of
nylon mesh was further modified by including a 3–mm thickness of tephra under the
nylon mesh between two sections. This layer of tephra was found to be adequate to halt
P diffusion from the HP soil to the LP soil for a plant growth period of 32 wk. Under
such circumstances, the increase in P uptake by plant growth in a combination of a root
zone of LP soil and a hyphal zone of HP soil compared with that in which both root and
hyphal zones were filled with LP soil was only ascribed to the transfer of P from HP soil
to LP soil by AMF hyphae. This novel root study container allows the biochar to be
added to either the root zone or the hyphal zone and separates the effect of biochar on
AMF hyphae development and P uptake from that on P content and availability (i.e.,
biochar rich in P; changes in soil pH). This device can contribute to discern whether
biochar can influence AMF development and enhance P bioavailability.
In order to investigate the feasibility of adding biochar to soils with high
residual P so that this can become bioavailable, Lotus pedunculatus cv barsille was
grown in LP and HP soils separately amended with BP450, BP550 and BW550 biochars
at an application rate of 10 t ha–1 using the novel root study container for 32 wk without
any further P and N fertilization. We found that (i) none of the tested biochars conferred
any specific advantage to the HP soil; (ii) the addition of BW550 biochar to the LP soil
increased plant growth by 59% and P uptake by 73%, while the pine–based biochar (e.g.,
BP450 and BP550) provided no extra nutrient uptake and no plant growth increase. This
was ascribed to supplemental nutrients (especially P) from the BW550 biochar along
with its liming effect and associated increase in P availability; (iii) biochar produced
from BP450 biochar caused a 70% P uptake increase (and 40% plant growth increase)
by stimulating AMF growth and accessing a high–P area (HP soil) to which the plant
root had no access. More research is needed to discern the underlying mechanism.
The liming effects of BW550 and BP550 biochars were further compared with
those of lime chemicals (e.g., Ca(OH)2 and NaOH) in a short–term (10–d) incubation
using two soils with contrasting pH–BC (an Haplic Cambisol and an Andic Umbrisol)
to which these amendments were added. The two soils were first amended with BW550,
BP550, Ca(OH)2 or NaOH at specific rates so that pH values of 5.4, 5.6, 5.8 and 6.4
were targeted and incubated at room temperature (25 oC) for 10 d. At the end of the
incubation, a radical elongation bioassay using alfalfa (Medicago sativa L.) was carried
out. Thereafter, soils were characterized with special attention to the Al chemistry, i.e.
aqueous reactive Al fractionation and inorganic monomeric Al speciation. The final
objective was to reveal the mechanisms through which these biochars alleviate Al
toxicity on roots. Results showed that, for a specific soil, a smaller amount of BW550
biochar was required to increase the same unit of pH and reduce a similar amount of
exchangeable Al compared with the amount required of BP550 biochar. The addition of
BW550 biochar (at application rates < 9.1 %) and Ca(OH)2 stimulated alfalfa
(Medicago sativa L.) seedling growth, whereas that of BP550 (at application rates >
2.4 %) and NaOH caused inhibition. The distinct responses of the root growth to the
presence of Ca(OH)2 and BW550 biochar and to that of NaOH and BP550 biochar were
explained by (i) a decrease in both inorganic monomeric Al (mainly in AlF2+ and Al3+)
and colloidal Al, and (ii) an increase in aqueous Ca2+, in the former, as expected. In the
latter there was (i) an increase in aqueous colloidal Al and Na+, and (ii) a decrease in
soluble Ca2+. Thus, BW550 biochar was shown to be a more effective liming agent than
was BP550 biochar.
The information obtained in this thesis supports the use of biochar to manage
high P affinity Andosols and acid soils, which are abundant in New Zealand. The
technology of producing biochar from willow woodchips or feedstock alike with
resultant solid products of high nutrient status and liming potential may contribute to the
recycle of nutrients while increasing soil pH. Pine woodchips produced at relatively low
temperature (e.g., 450oC) have been shown to enhance AMF abundance and
functionality. Thus, biochar with specific environmental and agricultural purposes
should be tailored accordingly. The root study container with a layer of “P diffusion
break” and the measurement of AMF hyphal length using the photomicrography in
conjunction with image software analysis (e.g., ImageJ) will advance studies of the
responses of AMF to soil additives (e.g., biochar or green waste) and their associated
enhancement of soil functions.
Description
Keywords
Biochar, Acid soils, Soils, Phosphorous content, Aluminum content, New Zealand