Studies of fault current limiters for power systems protection : a project report submitted in partial fulfilment of the requirements for the degree of Master of Engineering in Information and Telecommunication Engineering, Institute of Information Sciences and Technology, Massey University, Palmerston North, New Zealand

Malhi, Gurjeet Singh

Studies of fault current limiters for power systems protection : a project report submitted in partial fulfilment of the requirements for the degree of Master of Engineering in Information and Telecommunication Engineering, Institute of Information Sciences and Technology, Massey University, Palmerston North, New Zealand

dc.contributor.author	Malhi, Gurjeet Singh
dc.date.accessioned	2008-04-18T03:22:07Z
dc.date.available	2008-04-18T03:22:07Z
dc.date.issued	2007
dc.description.abstract	In today’s technological world, electrical energy is one of the most important forms of energy and is needed directly or indirectly in almost every field. Increase in the demand and consumption of electrical energy leads to increase in the system fault levels. It is not possible to change the rating of the equipment and devices in the system or circuits to accommodate the increasing fault currents. The devices in electronic and electrical circuits are sensitive to disturbance and any disturbance or fault may damage the device permanently so that it must be replaced. The cost of equipment like circuit breakers and transformers in power grids is very expensive. Moreover, replacing damaged equipment is a time and labour consuming process, which also affects the reliability of power systems. It is not possible to completely eliminate the faults but it is possible to limit the current during fault in order to save the equipment and devices in the circuits or systems. One solution to this problem is to use a current limiting device in the system. There are many different types of approaches used for limiting fault currents Two different approaches to limit fault currents have been discussed by the author. One is Passive Magnetic Current Limiter (MCL) and another is High Temperature Superconductor Fault Current Limiter (HTSFCL). Both are passive devices and they do not need any sensor or external sources to perform their current limiting action. The first device consists of two ferrite cores and a permanent magnet which is sandwiched between the two saturated cores and it is called Magnetic Current Limiter. Experimental results with the MCL in circuit are discussed. Both field and thermal models of the MCL have been simulated using finite element software, FEMLAB. The demonstration of the High Temperature Superconductor Fault Current Limiter (HTSFCL) in power systems has been explained. The MATLAB simulation of the HTSFCL has been done and the results with and without the fault are shown. Power System Analysis Toolbox (PSAT) software has been used to locate the optimum or the best location of HTSFCL in a nine bus system. It has been shown that it is possible to find a solution that limits the fault current in power systems. Depending on the size of the system, either the MCL or the HTSFCL can be implemented. The location of the HTSFCL is to be carefully selected to achieve optimum results.	en_US
dc.identifier.uri	http://hdl.handle.net/10179/617
dc.language.iso	en	en_US
dc.publisher	Massey University	en_US
dc.rights	The Author	en_US
dc.subject	Current limiting devices	en_US
dc.subject	Passive Magnetic Current Limiter	en_US
dc.subject	High Temperature Superconductor Fault Current Limiter	en_US
dc.subject	Simulation	en_US
dc.subject.other	Fields of Research::290000 Engineering and Technology::291700 Communications Technologies	en_US
dc.title	Studies of fault current limiters for power systems protection : a project report submitted in partial fulfilment of the requirements for the degree of Master of Engineering in Information and Telecommunication Engineering, Institute of Information Sciences and Technology, Massey University, Palmerston North, New Zealand	en_US
dc.type	Thesis	en_US
massey.contributor.author	Malhi, Gurjeet Singh
thesis.degree.discipline	Information and Telecommunication Engineering	en_US
thesis.degree.grantor	Massey University	en_US
thesis.degree.level	Masters	en_US
thesis.degree.name	Master of Engineering (M.E.)	en_US